Haunted House from Cricut Happy Hauntings Cartridge

I wanted to do smething for Halloween for the Cricut Club next week so I decided to do a Haunted House from Happy Hauntings Cricut Cartridge. My first mistake was to make it 11.5 inches high. Not a problem I had 24 inch paper but swapped to CCR half way through and forgot my sizing. and made all the parts too big. oops they did tell me anaesethics make the memory fuddled but I went back to the gypsy and my sturdy E2 and cut them again and voila here is my haunted houe. The house from the top of the spire to the ground is round 20inches or 50cm. It wont fir in a small box.

The roof with the top of the chimney and the spires

Looking own on the roof

The chimney from the side of the house

The dungeon doors

Back door and balcony

Side door

Front door

Angle showing front and chimney side

Love my brick work on the chimney I could be a Brickie

Love it

Just couldn't stop taking photos

Used illuminate iridescent ink pad plus interference to get the "painted" effect

Sort of looks like its a bit dirty

Hellooooo anybody thereeee

.